How to change tool lenght in the middle of G-code

RC-PPG@rc-ppg

15 Posts

#1 · February 17, 2021, 11:23 pm

Hello,

During the first cut's with MASSO I got a broken end mill.
I replaced the end mill and adjusted the new length directly into the DRO.
When I resumed the program I noticed that the new length didn’t take any effect only using the old depth.
Only after a rewind and new start from the last line it went ok.
How should I do this the better way?

Best regards,

Piet

Breezy@breezy

1,100 Posts

MASSO Support

#2 · February 17, 2021, 11:32 pm

@rc-ppg

Piet,

The correct way to change a broken tool is shown in this video, produced by Peter last week. (He must have known that you would need it)

Regards,

Arie.

RC-PPG@rc-ppg

15 PostsTopic Author

#3 · February 18, 2021, 4:24 am

Thanks,

Next project: Toolsetter!

Regards,

Piet