Forum Navigation
Please or Register to create posts and topics.

Post Processor for DeskProto

I am 90% sure I'm going to purchase a DeskProto license. I've been looking for a straightforward, not buggy, CAM package that isn't Fusion 360 or anything made by Autodesk, and managed to dig into this a bit on Monday. I made some successful cuts from GCode it generated. I used a generic GRBL post processor and it seemed to work fine but what I was doing was pretty simple.

I've looked at the documentation page on post processor requirements but I'm a little unclear on what would need to happen to make a Masso-Specific one for this package, or if it's even necessary. Can anyone point me in the right direction? Or should I simply use something that seems to work and hope for the best? In the past I used a Arduino/GRBL based system and it worked fine using the generic post processors that were provided in Fusion 360.

 

I have bought DeskProto 7 and now I have also a problem how to set up Post Processor for DeskProto

Who has settings how to make it?
I write to support Masso and no who answers ((

I am interested in the section in the Post Processor Start/End Settings control
what teams to register there?

I have registered in the section Start:
%
M03
M04
M07
M08
M10
M62
M64
G17
G21
G80
G90
G00
(Tool Number: [T]) ([TOOLDESC])
T[T] M06
[S] M3
G00 [XH] [YH] of [ZH] [RH]

in the section End Seting
M00
M01
M02
M05
M09
M11
M30
M63
M65
G00[ZH]

whether correctly I have made?

 

thanks