SOFTWARE RELEASE NOTES
MASSO Software Update – v3.40
Release date: 4th February 2019
- Easily control Spindle & Coolant from screen even while running a program.
- Added option to “Go to Work Origin” & “Single Block”
- Added option to display A & B work offset values including ZERO option.
- Added support for German (QWERTZ) keyboard layout.
- Changed the “Continuous Mode” flashing to red colour to visually alert user that the machine is on Continuous Mode.
- Added “Cancel” buttons in F1-Setup windows.
- Axis loosing position during probing cycle – bug fixed.
- Jump to line / resume (CTRL +J) – fixed issue with program resuming from wrong location when using temporary work offsets.
- Keyboard double character typing – bug fixed.
How to update the MASSO controller:
- Power off MASSO
- Copy the serial number.htg file and Data1.htg files that were emailed to the USB pen drive and do not copy these files to a folder
- Check that the above file names are not renamed by your browser when saving to the USB pen drive
- Unplug all USB devices from MASSO and only plug in the USB pen drive with the above two files to the USB pen drive connector of MASSO
- Power up the MASSO and wait for the yellow progress bar to go all the way to 100%
- Power off the controller and leave the USB pen drive plugged in, after about 5 seconds power up the unit
- Initially you will see a black screen for a few seconds while the update finishes
- Finally you will see the MASSO main screen and now you can connect USB hubs, keyboard and mouse to the system
- If you require you can delete the update files from the USB pen drive as they are not required anymore
Things to check after updating:
- After updating FIRST CHECK all settings in the F1-Setup screen and make sure all the settings are correct.
- Check Homing settings.
- Check Spindle settings.
- Check General settings, make sure “Limit maximum feedrate” is disabled if not being used.
- Check Lubrication settings.
- Check Tool Changer settings and also check the settings inside the tool changer settings.
- Check all axis settings.
- Check Auto Tool Zero settings and if not required then please disable it.
- Check all inputs and outputs, check that the right input shows the right function.
- Check that all inputs and outputs have the invert set as required.
- Check your tool calibration and work offset data.
- Finally before doing any cutting with the machine please do a few dry runs to make sure everything is working fine.
- You might see a “Backup battery fail detected” alarm, please DO NOT remove the battery on the controller and simply power cycle the controller and the message will automatically go away.